They should not be TSA locks. You should be the only one with the key or combination. A good idea is to place your name and email or ph # on the case in the unlikely event that they want to open the case before they load it on the plane. I do this when I have my locked case in my suitcase.
You...
Loctite only requires about 350-400F to break it's bond. I seriously doubt you caused any damage to the barrel unless it was damage from gripping the cap too tightly and deforming the threads.
Did you use Cerrosafe? If so it should met out with a heat gun or soldering gun. Maybe you had your plug too far down the bore and your casting has engaged the rifling.
I suppose a lot depends on how big a dick your judge is. I checked my recert the other day and it said it should have been done in 2023. I think I did go in and recert back then but I have no proof so this time I went through the process and saved my proof of recert. Funny thing is I know I have...
Your expander die should be able to be adjusted to leave a slight bell on the case mouth that will accept a bullet without shaving the jacket while sizing the inside of the case. This more so needed when loading cast bullets. Your seating die should also size the outside of the case as well as...
Yes if your tomatoes are low acid or if you are concerned use critic acid or lemon juice to lower the ph.
I have 10lbs of citric acid to use in canning and to clean my brass in my wet tumbler. :)
Can you slide a tool between the mag and the reciever from the top side with the bolt held back? The button that catches the pin on at the center of the mag should be accessible that way if you can get a still enough tool in there to jimmy the button back.
I suspect as said that either someone...
Why not buy winter tires and just change out each season? That way you have 2 sets that perform as they are designed to and you would not have to buy tires for another 4-5yrs.
That and Mavis sucks I would not recommend dealing with them.
It is funny because I was talking with a colleague today about electric vehicles, and we are a manufacturer of electric equipment and vehicles. One of our engineers referenced a study of just Germany, and if every car, truck and piece of equipment in Germany alone were switched to electric power...
I have accouple similar that I keep in my vehicles if I need to lock my handgun away. I also use them when I am flying. Mine are combination not key though.
This actually starts to take effect on 2028 model trucks. One of my coworkers was in a meeting with the EPA and CARB and was informed of the new regulations. The exhaust aftertreatment systems at that point will need to be equivalent of 3 systems using current technology to meet the standards...
The GF and I just did ours. on the first page after you log in at the top towards your left is a tab to apply for your DMP. Went through it without any issues. Took about 2 min each.
They are nice and should shoot MOA out of the box or at least the older FN version was supposed to. I don't know if the Browning variant has a chrome lined barrel either.
They are a little more of a pain to strip and mags are more expensive/harder to find than an AR.
https://www.ebay.com/itm/374038500884?hash=item57166e9614:g:15MAAOSwCxRiZH1h
This is not a bad deal especially if you make them an offer and they except. I have 2 of the 10-10 models.
Try the Tattler lids. You can get them on Ebay and Amazon as well as other sources. They are reusable. We have been using them for probably 15 years. The only thing is store them put of light and where ;pests \cant get to them as pests can chew through the lids
Unloaded and locked in a hard case yes. Trigger lock is not required and you can fly with ammo in your bag or with the firearm in the hard case if packed properly.
Oh and I recommend putting your name and cell # on the outside of the case, in case they need to contact you to open the case.