BMF JK
.44 mag

I’ve looked all over for reviews and all I’ve found was a couple reviews from tactical toolbox. Their slides look badass and are reasonably priced.
Last edited:
Cool. But those slides cost almost as much as an entire stock pistol.
I follow them on Instagram and like their cuts. I am a little worried about how aggressive the cut is. It might be a non issue or it might tear everything up. As far as quality I think they are on par with every other aftermarket slide manufacture.
@Edwardteach72 do you have source for G19 oem frames ? I’ve searched and all online sites I’ve found are always out of stock .
I’m considering buying a complete stock G19 then swap parts out as I get them , then I could always go back to stock if need be .
I’ll have to set up a notification with them . Every time I’ve checked their site the gen 4s are out of stock . Thanks !!
Yea its because glock doesnt sell just frames to anyone, and so how these guys get them is buy a whole gun then part it out, that's how you can get OEM frames and barrels.
Downside is all the parts sell slower than the frames so they will usually wait until they need the other stuff before parting out more full guns (or so that's how my hypothesis goes based on talking with glock themselves and seeing how often anyone has any in stock)
I agree it would help with all of that. I'm wondering on normal usage if it would be too much. I want to handle one badly. I still think my next one will be from these guys. Dynamic Weapon SolutionsI’m thinking those aggressive cuts would aid in one handed manipulation off someone’s forehead if necessary. Lol
DWS was another i was considering. They make some sweet looking slides .I agree it would help with all of that. I'm wondering on normal usage if it would be too much. I want to handle one badly. I still think my next one will be from these guys. Dynamic Weapon Solutions
Hey @Edwardteach72 I just happened to notice your CZ on the edc thread , sick by the way !! My question for ya is how do you like the rear sight set forward of the RMR ? I do understand the purpose one focal plain as opposed to multi plains . Is it significantly easier to focus on the target while placing the dot on target with that setup ? I’m about to order the norsso slide but trying to decide in the front or in the back ... the sight that is .
After a few financial setbacks errr responsibilities, I’m finally ready to get this venture into the custom cut slide with RMR thing .
Thank you sir ! Thats actually a great comparison , you can see how your eye would focus on the rear sight if positioned behind the rmr . Which is not what you want .Ok so again sorry about the bad picture quality.
Trying to do this with my cell phone in my hand kinda sucks lol
First up is the Irons infront of the RMR (on the CZ) View attachment 50428
Next is Irons behind the RMR (Glock)
View attachment 50429
This is a vid I’m kinda going by , seems legit .
Thanks for the info . I’ve seen his testing vids , he thoroughly beats the shit outta red dots in a realistic way .