Drill and easy outs 
Stuck bolt release plunger
- Thread starter Podmonkey
- Start date
Acer-m14
20×102mm Vulcan
2019 Step Drill Bit 3 13 Mm 1/4 Inch Hex Shank HSS Titanium Coated From Topyuan, $3.85 | DHgate.Com
Go to the Gun Show and See @Eddie Gunks
Go to the Gun Show and See @Eddie Gunks
repete
.338 Win Mag
Oil and set it 'upside down' and use a rubber hammer on the 'back' side, if that doesn't do it oil it let set overnight and repeat, spring is collapsed and probably broken and now no good so don't worry about it. If all else fails ask Eddie about the warranty.
I already tried that. I think drilling it out is the only thing left. When Eddie man gets back I might just send it to him. I hope he doesn't get his Thai gonosyphilherplaids all over it.Oil and set it 'upside down' and use a rubber hammer on the 'back' side, if that doesn't do it oil it let set overnight and repeat, spring is collapsed and probably broken and now no good so don't worry about it. If all else fails ask Eddie about the warranty.
BDinPutnam
.475 A&M Magnum
How about the broken screw extraction drill bit type thing? I dont know how small those bits get but that might be a way to get some hooks into it and get it out (runs reverse on your drill). I think I have a set at home I will look and see how small they are.
Exonautic
.308 Win
Couldn't find a small one. I stripped out the screwhead on the bullet guy mag lock trying to change out the mag to a different one and I'm still fighting with it.
tony
6.5 Creedmoor
The mallet on the back side is likely to drive pin in or stick it deeper. It's that inertia thing again. Hitting on the side it comes out from makes the pin and lower want to move in opposite directions so pin wants to come out.
Exonautic
.308 Win
Good point. Maybe combined with the pent up spring tension this could work.
ProgSpear
.338 Win Mag
Exonautic
.308 Win
Something something... Grenade for a snipers job.Why screw around? FIRE WRENCH!
Twogunwilly
6.5 Creedmoor
try a strong magnet while hammering on it, don't let Eddie touch it he's probably not going to give it back.
I dunno. I noticed the bolt stop was all loosely goosey so I took it off and saw that the plunger was stuck. Inclean my guns after every range trip........ usually.
Too lazy for that ATM.
carpediem
.338 Win Mag
Throw it in the freezer for a little while and then try removing it with needle nose pliers.